Common Questions About Ring Repairs

jewelry

Being able to keep your jewelry throughout most of your life is a gift, especially if the piece is an heirloom, passed on from generation to generation.

Unfortunately, these valuable items have their own lifetime that can eventually expire. The best thing we can do in order to avoid this from happening to preserve them. For this reason, we often look for a good jewelry shop that can offer jewelry repair in Tulsa, OK.

To fully understand what a jewelry repair shop has to offer, below are a few common questions about repairing rings that people often ask before the job gets done.

1. Do jewelers stretch rings to increase the size?

Normally jewelry repair shops do not stretch rings to increase the size, although some do this for particular types of rings. An example would be plain wedding band rings that are stretched to less than one size. In general, rings are sized up by adding a section of silver, gold, or platinum to the bottom of the shank. After this is done, they polish and refinish it to seal the sizing seam so there is no visible break.

2. How do jewelers size down a ring?

When a ring is sized down, a small portion of the bottom of the shank is cut out and the remaining sides are soldered back together. Then, a seam is polished and refinished to seal. This way, the ring appears like one whole piece again. After it is sized, the stones will eventually need to be retightened since they shift during the sizing process. Once the ring is sized and the stones are tightened, the ring is polished and refinished.

3. What happens during a refinishing?

When a piece of jewelry is being refinished, the main goal is to make it appear as good as new. The stones are checked to see if they are secure and tightened. When a white gold piece is refinished, a layer of Rhodium must be electromagnetically applied afterwards. Rhodium is what gives a refinished piece of white gold jewelry its bright white shine. Once it starts to become yellow, it is a sign that the Rhodium is slowly wearing off and that it needs to be refinished again.

4. How often should rings be checked?

It is recommended that you should get your ring checked at least every 6 months. If you have a ring with stones, it is only natural that there is wear and tear for the stones to loosen up over time and for prongs needed to be rebuilt or replaced. It is always best to catch a problem before the stone gets lost, so bringing your piece in to a jewelry repair in Tulsa, OK to have it checked regularly is essential for the longevity of your treasured piece.

5. What is the difference between lobster clasps vs spring ring?

There are two types of clasp repair: lobster clasp and spring clasps and they are constructed differently on the inside. Spring rings are more delicate and they cannot bear any form of heat. For this reason, they are never soldered onto a chain but they are carefully attached with pliers. Lobster clasps on the other hand are sturdier and they can take the heat of soldering thereby involving more labor and materials.

6. What is the difference between a shank and half a shank?

A shank is a part of the ring that goes under your finger. After some time, the shank becomes thinner because of regular use. This requires a shank replacement in order to bring it back to its original thickness. At times, only half of the shank is needed to be replaced because only that portion has worn away.

7. What is the difference between a tip and a full prong?

A tip adds a small amount of metal to an existing prong that has been worn down or slightly damaged. On the other hand, a full prong is when the entire prong is replaced and the seat for the stone is re-cut.

We know that over time, everything breaks down whether it is in the form of rusting, erosion, and the daily wear and tear. Since several people wear rings, they opt for jewelry repair in Tulsa, OK to prolong its life or to maintain it.